Attaching The Assemblies To The Frame - Air Lift LoadLifter 5000 Ultimate Installation Manual

NOTE
One of the 3/8"-16 x 1.25" carriage bolts (P) will not be covered by the roll plate and may fall
out. If so, retain for use in the "Attaching the Assemblies to the Frame" section later in this
installation guide.
10. Figure 14 shows the finished assemblies.

ATTACHING THE ASSEMBLIES TO THE FRAME

1. Drop the axle or raise the frame up to make room for the assemblies to be put into
2. Set the driver's (left) side assembly onto the jounce bumper strike plate (Fig. 15). Raise
3. Set the passenger's (right) side assembly into position on the axle the same way the
10
Driver's
(left) side
position.
the axle up just enough to insert the long carriage bolt (M) that is installed in the upper
bracket (Figs. 10 & 11) through the existing jounce bumper hole in the bottom of the
frame. At the same time, line up the upper brace previously installed onto the remaining
two carriage bolts (P) in the upper bracket. Do this just enough for the carriage bolt to
hold the assembly into position on the jounce bumper strike plate.
fig. 15
left side was positioned (Fig. 15b).
LoadLifter 5000 Series
Passenger's
(right) side
fig. 14
fig. 15b
MN-1053