Toolbar; Waveform Screen - Philips ST80i Instructions For Use Manual

An Overview of the ST80i Stress Test System

Toolbar

The Toolbar contains the Toolbar icons that are used during the patient session. The icons
provide quick access to frequently used commands.
During the patient session, the waveform screen is displayed. You can use the Toolbar icons
during the patient session to view or hide specific exercise stress test data - which appear as an
overlay on the waveform screen.
Some of the icons allow you to change specific default settings as you proceed through each
phase of the patient session, while others give you a magnified view of various data in relation
to the ECG.
When you mouse over each icon, a Tool Tip is displayed.
See "Using the Toolbar Icons" on page 2-15 for a complete description of the icons and their
functionality.
The default setting for the Toolbar is at the top of the screen. You can change the location of
the Toolbar to the bottom of the screen. See the ST80i Installation and Configuration Guide to
change the default setting [Settings  User Profile  Display].

Waveform Screen

Real-time ECG waveforms appear on the Waveform screen. The default setting is 12-Lead.
With the customizable options of ST80i, you can use the Toolbar icons do the following:
Change the default lead you want to view (12, 6x2, 6, 3)

Display the magnified beat

Display and/or print the average complexes

Show or remove magnified beat, trends, anatomical representations and average

complexes from the ECG print strip
On the bottom of the screen, the current settings appear for the following:
Limb Lead amplitude

Chest Lead amplitude

Speed of trace display

Filter – low and high pass

Figure 2-6
When you change these default settings using the Toolbar icons, they appear in this location.
2-10 ST80i Stress Test System Instructions for Use
Limb Lead, Chest Lead, Speed, and Filter Settings