Nibp & Spo2; Override Nibp And Spo2 - Philips ST80i Instructions For Use Manual

NIBP & SpO
ST80i supports optional SpO
devices. ST80i automatically collects the NIBP through a cuff. The patient's SpO
in real-time through a sensor.
NIBP and SpO
study or for a single instance. They can be manually measured and the values can be
overridden.
During the stress test, NIBP and SpO
exercise protocol and are continually displayed on the screen. This will be recorded in the
field in the Side Panel and also on the ECG. The SpO
BPmmhg
recorded in the Side Panel in the SpO
If enabled, there are also audible prompts for NIBP and SpO
the ST80i Installation and Configuration Guide.
To connect the patient to the NIBP device
Place the cuff on the patient.
1
Take a pre-stress NIBP connection test to determine if the cuff is correctly placed on the
2
patient and to ensure NIBP measurements throughout the stress test.
To connect the patient to an SpO
 Place the SpO
an SpO value.
2
Override NIBP and SpO
When you enter or acquire blood pressure values according to the pre-programmed automatic
prompts or at any other times during the test, for each recording, the blood pressure value,
phase, and total time of the phase at the time of the acquisition are captured.
The automatic timing of blood pressure measurements is established in the exercise protocol.
You can, however, take blood pressure measurements at any time during each stage by using
the button. Or you can enter the measurement manually, after taking the patient's blood
BP
pressure.
When you override the values of NIBP and SpO
and the Final Stress Report.
N O T E Once the NIBP or SpO
values from the NIBP monitor.
2
and motion-tolerant Non-Invasive Blood Pressure (NIBP)
2
are real-time numeric displays for the NIBP and SpO2 values for an entire
2
2
2
sensor
2
sensor on the patient's finger. connection test. The screen should display
2
2
is manually overwritten, ST80i no longer updates the real-time NIBP or SpO
2
are measured according to the intervals defined in the
2
field.
. To enable audio prompts, see
2
, they will be displayed in the Stage Report
2
ST80i Stress Test System Instructions for Use
Preparing the Patient
is collected
2
measurement will also be
2
3-29