Continuous Rhythm Strip; De-Identification - Philips ST80i Instructions For Use Manual

The Patient Session
Maximum ST changes in this stage (for Stage printout only)

Current ST change (for Stage printout only)


Continuous Rhythm Strip

You can trigger continuous rhythm printing using the
screen. You can also turn off continuous printing by using the same
Before using the Rhythm Print option, you can:
ST80i software automatically advances the paper to the page header

You can adjust Rhythm Print settings using the

To print a continuous Rhythm Strip
Click the
1
Adjust the settings, if applicable, for:
2
– Leads (Select the leads you want to print)
– Limb Gain (options include: 2.5 mm/mV, 5 mm/mV, 10 mm/mV, 20 mm/mV)
– Chest Gain (options include Full, Half)
– Speed (options include 5 mm/s, 10 mm/s, 25 mm/s, 50 mm/s)
Click the
3
To end the printing, click the
4

De-Identification

When printing patient reports, you can de-identify the study to be in HIPAA compliance. This
option hides all patient identification information from the study printout so that the identity of
the patient is protected.
This option is preconfigured in the Settings section of the application.
To de-identify a patient
Click
1
Select the
2
Select the
3
Place a checkmark in the "De-identify Patient Information on Report" box
4
Click
5
Proceed to "Ending the Patient Session," which follows.
3-46 ST80i Stress Test System Instructions for Use
Gear (Quick Settings)
icon
Rhythm Print
Rhythm Print
on the Main Screen.
Settings
tab
System Settings
option
System
.
Save
Rhythm Print
Gear (Quick Settings)
icon; select the
Rhythm Print
icon again.
button on the Exercise
button.
Rhythm Print
icon
tab.