3B-17 Differential: Front
27) Clean mating surface of right retainer, carrier (1) and
rear cover (2), apply sealant to carrier and rear cover
as shown in figure by such amount that its section is
1.5 mm (0.059 in.) in diameter, mate right retainer
with carrier and rear cover, and then tighten bolts to
specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Retainer bolt: 50 N·m (5.0 kgf-m, 36.5 lb-ft)
2
28) Clean mating surface of front drive shaft retainer,
carrier (1) and rear cover (2), apply sealant to carrier
and rear cover as shown in figure by such amount
that its section is 1.5 mm (0.059 in.) in diameter,
mate front drive shaft retainer with carrier and rear
cover, and then tighten bolts to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Retainer bolt: 50 N·m (5.0 kgf-m, 36.5 lb-ft)
1
www.CarGarage.ir
29) Install front drive shaft using plastic hammer.
30) Install front differential rear mounting (1).
"A"
31) Install front differential right mounting (1).
1
I5JB0A321048-01
Front Differential Inspection
• Check companion flange for wear or damage.
2
• Check bearings for wear or discoloration.
• Check differential carrier for cracks.
• Check drive bevel pinion and drive bevel gear for
"A"
• Check differential gears, pinions and pinion shafts for
I5JB0A322014-01
• Check differential gear spline for wear or damage.
www.CarGarage.ir
Tightening torque
Rear mounting bracket bolt (a): 50 N·m (5.0 kgf-
m, 36.5 lb-ft)
1
Tightening torque
Right mounting bracket bolt (b): 50 N·m (5.0 kgf-
m, 36.5 lb-ft)
wear or cracks.
wear or damage.
(a)
I5JB0A321046-01
1
(b)
I5JB0A321047-02
S5JB0A3216011