Suzuki Grand Vitara Service Manual page 20

3B-7 Differential: Front
b) Make mating marks (1) on drive bevel pinion and
companion flange.
CAUTION
!
Do not make mating mark on the coupling
surface of the flange.
c) Remove flange (2) from drive bevel pinion. Use
special tool if it is hard to remove.
Special tool
(A): 09913–65135
(B): 09925–88210
1
d) Remove drive bevel pinion (1) with rear bearing,
shim and spacer from carrier.
If it is hard to remove, screw an used nut (2) into
drive bevel pinion and hammer (3) on that nut
with a plastic hammer but never directly on drive
bevel pinion.
1
2
(B)
(A)
2
I5JB0A321017-02
3
2
I5JB0A321018-01
www.CarGarage.ir
e) Remove drive bevel pinion rear bearing (2) by
using bearing puller (3) and hydraulic press.
CAUTION
!
To avoid rear bearing from being damaged,
support it at flat side of bearing puller.
1. Drive bevel pinion
10) Remove oil seal (1) using special tool.
Special tool
(A): 09913–50121
11) Using a hammer and brass bar (1), drive out front
bearing outer race (2).
www.CarGarage.ir
I1JA01322006-01
(A)
1
I5JB0A321019-01
I5JB0A321020-01