Configuring The Sdr Hostname; Configuring The Management Ethernet Interface - Cisco XR 12000 Series Getting Started Manual

Configuring the SDR Hostname

RP/0/0/CPU0:router(config-if)# description this is my interface
RP/0/0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.0.0.0
RP/0/0/CPU0:router(config-if)# shutdown
RP/0/0/CPU0:router(config-if)# abort
RP/0/0/CPU0:router#
Configuring the SDR Hostname
The hostname identifies an SDR on the network. Although devices can be uniquely identified by their
Layer 2 and Layer 3 addresses (such as an IP address), it is often simpler to remember network devices
by an alphanumeric "hostname." This name is used in the CLI prompt and default configuration
filenames and to identify the SDR on the network.
To configure the hostname, enter the hostname command with the SDR name as shown in the following
example:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# hostname SDR_SJ
RP/0/0/CPU0:router(config)# commit
RP/0/0/CPU0:Apr
committed by user 'user_a'.
the changes.
RP/0/0/CPU0:SDR_SJ(config)#
The preceding example sets the SDR name to SDR_SJ.
No blanks or spaces are permitted as part of a name. Do not expect case to be preserved. Uppercase and
Note
lowercase characters look the same to many Internet software applications. It may seem appropriate to
capitalize a name the same way you might if you were writing, but conventions dictate that computer
names appear all lowercase. For more information, see RFC 1178, Choosing a Name for Your Computer.

Configuring the Management Ethernet Interface

The Management Ethernet interface on the RPs is used to connect the router to a network for remote
management using a Telnet client, the Simple Network Management Protocol (SNMP), or other
management agents. The following sections provide information on the Management Ethernet interface:
•
•
•
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
3-66
7 00:07:33.246 : config[65669]: %LIBTARCFG-6-COMMIT : Configuration
Specifying the Management Ethernet Interface Name in CLI Commands, page 3-67
Displaying the Available Management Ethernet Interfaces, page 3-67
Configuring the Management Ethernet Interface, page 3-68
Use 'show configuration commit changes 1000000067' to view
Chapter 3 Configuring General Router Features
OL-24755-01