Parameter Setting / Download Via Tool - Siemens RDF301 Basic Documentation

ACS
OZW772 Web server,
RMZ792 bus operator
unit
ETS
Note:
Connecting a KNX tool
Siemens
Building Technologies

3.14.2 Parameter setting / download via tool

3.14.2 Parameter setting / download via tool
Control parameters can be adjusted via bus either by parameter download during Control parameters can be adjusted via
commissioning or during normal operation with a tool like ACS. commissioning or during normal operation with a tool like ACS commissioning or during normal operation with a tool like ACS
With the the ACS tool, the parameters can be changed...
– during commissioning via during commissioning via parameter download (all parameters)
– during normal operation during normal operation via Popcard (most of the parameter
Most parameters can be changed during normal operation using Most parameters can be changed during nor
server or server or the RMZ792 bus operator unit.
ETS is an engineering tool and can be used for the full commissioning of the RDF ETS is an engineering tool and can be used for the full commissioning of the ETS is an engineering tool and can be used for the full commissioning of the
KNX thermostat thermostats. Device address, application, control parameters and parameters . Device address, application, control parameters and parameters
for the switching groups can be defined and downloaded via ETS for the switching groups can be defined and downloaded via ETS.
∂ Setting RDF KNX parameters is only supported by ETS4 or higher / ACS version
Setting RDF KNX parameters is only supported by ETS4 or higher / ACS version Setting RDF KNX parameters is only supported by ETS4 or higher / ACS version
5.11 or higher. 5.11 or higher.
∂ The RDF KNX thermostats (without ETS parameter download) require version
The RDF KNX thermostats (without ETS parameter download) require version The RDF KNX thermostats (without ETS parameter download) require version
ETS3f or higher. ETS3f or higher
Connecting Connecting a KNX commissioning / operating tool to the a KNX commissioning / operating tool to the RDF is described in
section 4.2. section
RDF301, RDF301.50..., RDF600KN RDF301, RDF301.50..., RDF600KN, RDF600KN/S
parameter download during
download (all parameters)
most of the parameters).
mal operation using the OZW772 web
Basic Documentation ocumentation
69 / 94
CE1P3171en
2017-12-07