Operation - Siemens RDF301 Basic Documentation

Layout
1
RDF301, RDF600KN RDF301, RDF600KN
RDF301.50,
RDF600KN/S
RDF301.50H
Button operation
Siemens
Building Technologies
4.3

Operation

See also also Operating Instructions B3171 [2] enclosed with the
2
1
4
3
1 Operating mode selector 1 Operating mode selector
2 Button to change fan 2 Button to change fan operation
3 Buttons to adjust setpoints and control parameters 3 Buttons to adjust setpoints and control parameters
4 Four buttons to control KNX actuators via KNX 4 Four buttons to control KNX actuators via KNX S-Mode
(functions: switching, dimming, blind control, 8 (functions: switching, dimming, blind control, 8-bit scene)
5 Four dedicated buttons for hotel functions (Make Up Room, Do Not Disturb) via 5 Four dedicated buttons for hotel functions (Make Up Room, Do Not Disturb) via 5 Four dedicated buttons for hotel functions (Make Up Room, Do Not Disturb) via
KNX S-Mode (functions: switching) KNX
User action User action
Normal operation Normal operation
Press any button Press any button
(thermostat in normal operation) (thermostat in normal operation)
Press left button Press left button (operating mode)
Press left button (P01 = 2) left button (P01 = 2)
Press left button while "Operating Press left button while "Operating
mode switchover" via bus is activated mode switchover"
Press left button >5 / >3 seconds Press left button >5
(RDF301 (RDF301... / RDF600KN...)
Press right button Press right button
Press + or – Press + or
Press + and Press + and – >3 seconds, release,
then press + again >3 seconds then press + again >3 seconds
Press + and Press + and – >3 seconds, release,
then press – again >3 seconds then press
Press operating mode button and Press operating mode button and "+"
simultaneously for 6 sec simultaneously for 6 seconds
RDF301, RDF301.50..., RDF600KN RDF301, RDF301.50..., RDF600KN, RDF600KN/S
enclosed with the thermostat.
3
RDF301.50, RDF600KN/S
Effect, description Effect, description
Actual operating mode and ctual operating mode and state are
indicated by symbols indicated by symbols
Backlit LCD turns on and... acklit LCD turns on and... (see below for
further action)
After the last operation and a timeout of 10 After the last operation and a timeout of
seconds, the LCD backlight turns off seconds, the LCD backlight turns off
Change operating mode Change operating mode
Toggle between heating and cooling Toggle between heating and cooling
Activate "Extend Comfort mode" Activate "Extend Comfort mode"
(for details, see page 20) (for details, see page
Activate / deactivate button lock Activate / deactivate button lock
Change fan mode Change fan mode
Adjusts the Comfort room temperature Adjusts the Comfort room temperature
setpoint .
Thermostat changes to Comfort mode Thermostat changes to Comfort
Go to parameter setting mode "Service Go to parameter setting mode
level"
Go to parameter setting mode "Expert Go to parameter setting mode
level", diagnostics and test , diagnostics and test
Enter (KNX) programming mode
Basic Documentation
2
1
5
4
3
RDF301.50H
Mode
bit scene)
rogramming mode
ocumentation CE1P3171en
2
5
77 / 94
2017-12-07