Display Unit Cable - Simrad HS52 Instruction Manual

Note!
Note!
20222360 / E

Display Unit Cable

The 15 m cable to the Processing unit has connector only at the
Display unit end. Optional extensions cable (10 m) is available
and has a male and a female connector.
The connector is of crimp type. It can be easily disassembled, if
desired for ease of installation. The extracting tool (p.no.
44161792) may be ordered from Simrad.
HOW TO REMOVE PINS:
Extraction tool
Insert tool in slot
See the table below for pin configuration and color code for this
cable. DO NOT MIX THE PINS AND THE CABLE COLORS!
Apply a thin layer of pure Vaseline on the connector threads
and make sure the connectors are properly secured to the
receptacle by the coupling ring. The connectors are weather
proof according to IP56, when properly installed. The plug must
be fitted with the plastic cap to keep the connector free of dirt
and moisture. A separate screw cap for the Display unit comes
as part of the installation kit.
Display Unit Cable
Cable Color
pairs code
st
1 pair Pink
Grey
nd
2 pair Brown
White
rd
3 pair Yellow
Green
For installations that require special cable length, contact your
Simrad distributor for information.
Processing
Unit
Connect Terminal
or pin pin
5 PWR
4 GND
1 Bus–
2 Bus+
3 POWC
6 ALARM
INSTALLATION
Pull the wire
6
1
5
2 4
3
FRONT VIEW
17