Diag / Side Of Vehicle Connection - BPW ECO Tronic EBS Operating And Installation Instructions

3 Chassis installation
3.2 Electrical wiring
3.2.11 „DIAG" /
Side of vehicle connection
Diagnostic „DIAG" - side of vehicle connection
- Option 3
Mount the diagnostic connector on the outside of the main
chassis rail. The position must be in an accessible area but not
in the direct spray of the wheels (Fig. 60).
Clearance and mounting dimensions (Fig. 61).
Shaded area around hole to be fl at and free from raised markings
or surface imperfections which may prevent fl ush fi tting of the
connector.
The connector must be mounted horizontally.
Tighten nut (Fig. 61/1) to a torque of 3 - 4 Nm.
ECU connection is as Fig 58/59.
Cable to run up to connector and secured to the chassis,
or appropriate cable or pipe runs, with cable ties at 400 mm
intervals.
Ensure that the cover is fi tted and correctly 'locked' in place
(Fig. 62).
38
Alt
Fig. 60
min. 40 mm min. 40 mm
max.
Ø 50 mm
max.
Ø 24 mm
1
min.
100 mm
Fig. 61
Fig. 62
min. min.
120 mm 65 mm
max. 400 mm