Diag Connections - BPW ECO Tronic EBS Operating And Installation Instructions

3.2.10 „DIAG" connections
Diagnostic „DIAG" connection - Option 1
If no diagnostic units are to be installed retain blanking plug in
position marked „DIAG" (Fig. 57).
Diagnostic „DIAG" connection - Option 2
If a remote mounted Trailer Monitor is installed remove blanking
plug (Fig. 58).
Identify orientation of the diagnostic green coloured
connector (Fig. 59).
Ensure contact pins and seal are clean and free
of any contamination prior to installation.
In position „DIAG", on the slide lock housing, insert
connector fully home. Then lock the housing.
Fig. 57
Fig. 58
rt
Green connector
Fig. 59
3.2 Electrical wiring
37