Error Codes; Calibration - Adam Equipment SWZ 6D User Manual

1) Press the [Tare]
2) Press the [Tare]
An error code will be shown if the time (Err 1) or the date (Err 2) is not the permissible values.
For example, 34 th
5.0

ERROR CODES

During the initial power-on testing or during operation, the scale may show an error code in
which case consult the table below. If the error persists, contact your dealer for further support.
ERROR
Err 1
Err 2
Err 4
Err 6
6.0

CALIBRATION

The SWZ scales are sealed to prevent unauthorised calibration.
Contact Adam Equipment or your supplier for more details.
WARNING: CALIBRATION OF THE SCALES MAY MAKE IT ILLEGAL TO USE THE SCALES
FOR SALES OF GOODS. CONTACT YOUR TRAIDING STANDARDS OFFICE FOR
FURTHER ASSISTANCE.
© Adam Equipment Co Ltd 2018
↵
key to accept the chosen format and then enter the date in this format.
↵
key to accept the date.
day of a month is an invalid entry.
DESCRIPTION
Time input error.
Date input error
Initial Zero is greater than
allowed (typically 4% of
the maximum capacity)
when power is turned on
or when [Zero] is pressed,
A/D count is not correct
when turning the scale on.
POSSIBLE CAUSES
Tried to set an illegal time, i.e.
26 hours
Tried to set an illegal date, i.e.
th
36 day
Weight is on the pan when
turning the scale on.
Excessive weight on the pan
when zeroing scale. Improper
calibration of the scale.
Damaged load cell.
Damaged Electronics.
Platform is not installed. Load
cell is damaged.
Electronics is damaged.
18