Entering Values For The Plus - Adam Equipment SWZ 6D User Manual

The user can store and recall up to 99 PLU values (PLU00 to PLU99) using the [PLU+] key.
To recall one of these PLU values the following procedure applies:
1) To recall a PLU value, press [PLU+]. The display will show "store" or "recall" – press
digits [1] or [6] to change the selection.
2) Once selected, "PoS 00" " " will appear in the Price to Pay display. Enter a number
(00 to 99) to save the value against the number selected.
3) Once complete, the value can be recalled by selecting "recall" using the previous steps
and entering the saved PLU number.
For example:
Press [PLU+].
Press [1] and then [4] immediately.
Display will show "LOAd" "PoS 14" " " and then the PLU value for PLU 14 will be displayed.
If the item is loaded on the pan, the Total Price window will show the total cost. If nothing is
loaded, only the PLU value saved for the location will be displayed in the Unit Price window
and the Total Price window will display "0,00 ".
4.5

ENTERING VALUES FOR THE PLUs

To store values for the [PLU+] key into the memory follow the procedure:
1) Enter the unit price value using the keypad, selecting either price/kg or price/100g if
needed.
2) Press and hold down the key [PLU+] for more than 3 seconds till a beep is heard, then
release the key. It will show "Store"
3) Press the [tare] key to show "PoS 00" "
© Adam Equipment Co Ltd 2018
" on the price to pay display.
12