Table of Contents
Advertisement
SERVICE
THERMOSTAT
REPLACEMENT
NOTICE
!
CAUTION
31
8. Pull the thermostat probe out of the wash tank.
9. Place the new thermostat probe in the new imperial brass fitting provided in
your kit. Use the 7/16" wrench to tighten it down after getting the fitting hand-
tight in the tank.
10. Replace the thermostat bracket with the 3/8" nutdriver (Step 6 in reverse).
11. Place the new ELAN thermostat on the bracket and secure it with the phillips
screwdriver.
12. Reconnect the wires per the machine schematic on the back of the door.
13. Place the drain stopper back in the wash tank. Restore power and water to
the unit. Then allow the unit to operate normally.
14. Verify that the thermostat operates the heater contactor. Once you have
determined the heater contactor is working, adjust the wash tank thermostat
to ensure that the temperature is maintained in accordance with the
specifications on the machine data plate.
15. Replace the heater cover.
16. Replace the front door.
Work performed on dishmachines by unauthorized or unqualified
personnel may void the warranty. Before beginning this or any other
maintenance on a unit under warranty, you should contact a manufacturer-
certified technician or the manufacturer's Technical Service.
SERVICE PROCEDURES
07610-003-62-15-Q
Hide quick links:
Advertisement
Table of Contents
