Table of Contents
Advertisement
SERVICE
CHEMICAL FEEDER
PUMP MOTOR
REPLACEMENT
NOTICE
!
CAUTION
23
10. Once the screws are removed, the motor should drop away.
11. Cut away any tie-wraps that are holding the power wires and remove the
motor.
12. Take your new motor and attach new terminals to the wires as required.
13. Re-mount the motor to the pump.
14. Place the roller and the rubber tube back in the pump casing. Place the
pump cover back on and tighten-down with the four screws previously
removed.
15. Re-attach the power wire and the wire for the priming switch.
16. Put the cover back on the control box and secure with the two screws
previously removed.
17. Ensuring that all non-essential personnel are clear of the area and restore
power to the unit. Turn the unit on. Using the priming switch, verify that the
feeder pump operates and pumps fluid.
18. Replace the front door.
Work performed on dishmachines by unauthorized or unqualified
personnel may void the warranty. Before beginning this or any other
maintenance on a unit under warranty, you should contact a manufacturer-
certified technician or the manufacturer's Technical Service.
SERVICE PROCEDURES
07610-003-62-15-Q
Hide quick links:
Advertisement
Table of Contents
