Table of Contents
Advertisement
SERVICE
THERMOSTAT
REPLACEMENT
These machines
come equipped with a
thermostat to ensure
proper warewashing
results. Occasionally, this
component might need
replacing.
The instructions provided
here are for maintenance
personnel only.
Unauthorized persons
should not attempt any
of the steps contained in
these instructions.
29
CAUTION! Many of the instructions and steps within this document
!
require the use of tools. Only authorized personnel should ever
perform any maintenance procedure on the dishmachine!
CAUTION
PREPARATION
•
Power must be secured to the unit at the service breaker. Tag or lock-out
the service breaker to prevent accidental or unauthorized energizing of the
machine.
•
Ensure that incoming water to the machine is secured either by use of a
shut-off valve or disconnecting the incoming water line.
•
The unit must be drained completely with the drain stopper removed.
TOOLS REQUIRED
•
3/8" Nutdriver
•
7/16" Nutdriver
•
7/16" Wrench
•
Needle-nose Pliers
•
Phillips Screwdriver
IMPORTANT NOTES
•
Read these instructions thoroughly before attempting this maintenance task.
Become familiar with the parts and what actions need to be taken. This will
save time in the long run!
•
These instructions show steps on only one of the three motors. However, the
steps are the same for each one.
STEPS
1. Remove the front door.
2. Remove the heater box cover with the 3/8" nutdriver. Set the cover and
hardware to the side.
SERVICE PROCEDURES
07610-003-62-15-Q
Hide quick links:
Advertisement
Table of Contents
