Electrical Requirements - Jackson DELTA 115 Installation, Operation And Service Manual

ELECTRICAL REQUIREMENTS

NOTICE
All electrical ratings provided in this manual are for reference
only. Always refer to the machine data plate to get exact electrical
information for this machine. All electrical work performed on
machines should be done in accordance with applicable
local, state, territorial, and national codes. Work should only
be performed by qualified electricians and authorized service
agents.
Note that all electrical wiring used in the Delta
must be rated, at a minimum, for 212 °F (100 °C), and that only
copper conductors must be used.
Where applicable, heating element amperage draws have been
adjusted for the assumed input voltage. The manufacturer
assumes incoming voltages will be either 208 or 230 Volts. Some
heating elements used in the machines could be rated for other
voltages, so always verify the amperage draw of the machine in
operation when sizing circuit protection.
If the dishmachine is equipped with an optional rinse heater, note
the rinse heater might have its own electrical connection and
require a separate service. Amperage loads for motors and heaters
are indicated on the machine data plate.
07610-003-62-15-Q
i
series of machines
®
SPECIFICATIONS
Delta
Electrical Characteristics
VOLTS 208
PHASE 1
FREQ 60
WASH
MOTOR 0.5 A
AMPS
WASH
HEATER 13.0 A
AMPS
TOTAL
13.5 A
LOAD
Delta
Electrical Characteristics
VOLTS 115
PHASE 1
FREQ 60
WASH
MOTOR 3.1 A
AMPS
WASH
HEATER 11.3 A
AMPS
TOTAL
14.4 A
LOAD
1200
®
230
1
60
0.4 A
14.4 A
14.8 A
115
®
4