Subscribe to Our Youtube Channel
Related Manuals for ApexDesk AL6528-3M Series
Summary of Contents for ApexDesk AL6528-3M Series
- Page 1 ELECTRIC HEIGHT-ADJUSTED SIT TO STAND DESK Vortex Series L-shape Desk Assembly Guide For desk with underframe Model No. AL6528-3M-XXX (memory controller) For desk with underframe Model No. AL6528-3B-XXX (non-memory controller)
-
Page 2: Table Of Contents
Table of Contents IMPORTANT SAFETY INSTRUCTIONS ....................3 CAUTION, USE & LIABILITY .......................... 4 PARTS & HARDWARE ............................. 5 ASSEMBLY INSTRUCTIONS ........................6 WARRANTY INFORMATION ........................11 CONTACT INFORMATION .......................... 11 P a g e... -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS WARNING –When using electric appliances, basic precautions should always be followed, including the following: a) Read all the instructions before using the appliance. b) To reduce the risk of injury, close supervision is necessary when an appliance is used near children. c) Do not contact moving parts. -
Page 4: Caution, Use & Liability
CAUTION, USE & LIABILITY CAUTION Make sure no obstacles are in the desk’s path. Make sure the desk top is not touching any walls. Make sure all cords have appropriate length to accommodate the change in desk height. Keep children away from electric sit to stand desks, control units and handsets. Keep all electrical components away from liquids. -
Page 5: Parts & Hardware
PARTS & HARDWARE PARTS DIAGRAM Tabletop Support Bracket L-shape Beam Controller Long Foot Short Foot PARTS LIST L-shape beam x 1 leg x 3 controller x 1 short foot x 1 long foot x 1 support bracket x 3 HARDWARE LIST ST3x12 Screws 2pcs... -
Page 6: Assembly Instructions
ASSEMBLY INSTRUCTIONS BEFORE YOU BEGIN 1. Lay out all components and hardware to ensure that you have everything listed on Page 5. 2. The desk weighs close to 100 lbs. Two people are needed to turn or move desk top and some components. - Page 7 Turn leg slightly to sit spindle into gear Legs should be perpendicular to beam STEP 2 Use Screw F to secure long and short foot to the beam. Make sure to use longer socket-headed BLACK screw F not shorter dome-headed Screw A. The foot is hollow.
- Page 8 STEP 3 Turn the assembled underframe over and use Screw A to secure three upper supports to the beam. STEP 4 Lay the tabletop on a soft and non-abrasive surface. Carefully move the underframe onto the top, align the holes on the upper supports to the pre-drilled anchors on the top. Secure the top with Screw A. Don’t over- tighten the screws.
- Page 9 STEP 5 Use Screw H to mount memory controller and Screw G to mount non-memory to tabletop. Please note that pre-drilled holes are only available on the right side. Non-memory controller looks identical on both sides. The upper side of non-memory controller is labeled “Attach this side to tabletop”. Label Non-memory controller...
- Page 10 Desk goes up or down unevenly. Make sure the spindles are set properly into the gear boxes. Unplug the power from the source to reset controller. If the problem persists, send an email to support@apexdesk.com. 10 | P a g e...
-
Page 11: Warranty Information
ApexDesk’s obligation under this warranty is limited to the repair or replacement, at ApexDesk’s sole option, of the parts or products the defect of which are reported to ApexDesk within the applicable warranty period and which, upon examination by ApexDesk, prove to be defective.
Need help?
Do you have a question about the AL6528-3M Series and is the answer not in the manual?
Questions and answers