Removing A Media Card Reader - Dell Dimension 9200 Service Manual

Documentation
4. Slide the floppy drive into the floppy drive bay until the sliding plate clicks into place and the drive snaps into position.
5. Attach the power cable to the floppy drive. Attach the floppy-drive cable to the floppy drive and to the system board.
6. Check all cable connections. Fold the ribbon cable and place it across the top of the processor shroud inserting the sides
under the clips. Ensure that the cable does not block airflow for the fan and cooling vents.
7. Replace the computer cover.
NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the
computer.
8. Connect your computer and devices to their electrical outlets, and then turn them on.
See the documentation that came with the floppy drive for instructions on installing any software required for the
operation of the drive.
9. Enter system setup (see
10. Verify that your computer works correctly by running the Dell Diagnostics (see
Media Card Reader

Removing a Media Card Reader

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
1. Follow the procedures in
2. Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3. Remove the computer cover (see
4. Remove the drive panel (see
5. Remove the drive panel insert (see
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (37 of 68) [12/9/2007 11:22:24 PM]
Setup) and select the appropriate Diskette Drive option.
Entering System
Before You Begin.
Removing the Computer Cover).
Removing the Drive Panel).
Removing the Drive-Panel
Dell Diagnostics).
Insert).