Installing The System Board - Dell Dimension 9200 Service Manual

Documentation
1 system board
10. Remove the 10 screws from the system board.
11. Slide the system board assembly toward the front of the computer, and then lift the board away.
12. Place the system board assembly that you just removed next to the replacement system board to ensure that it is
identical.

Installing the System Board

1. Gently align the board into the chassis and slide it toward the back of the computer.
2. Replace the screws on the system board.
3. Replace any components and cables that you removed from the system board.
4. Install the memory modules that were removed from the old system board (see
5. Reconnect all cables to their connectors at the back of the computer.
6. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into
the computer. Connect your computer and devices to electrical outlets, and turn them on.
If the new system board requires flashing the BIOS refer to
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (66 of 68) [12/9/2007 11:22:24 PM]
2 screws (10)
Replacing the Computer Cover).
Flashing the BIOS.
Installing Memory).