Dell Dimension 9200 Service Manual page 67

Documentation
1 fully seated card
4 bracket caught outside of slot
10. Ensure that:
The tops of all cards and filler brackets are flush with the alignment bar.
●
The notch in the top of the card or filler bracket fits around the alignment guide.
●
11. If you removed a card retention mechanism, snap it into place, securing the PCI-E card.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.
NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the
computer.
12. Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
13. If you installed a sound card:
a. Enter system setup, select Integrated Audio Controller, and then change the setting to Off.
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the
integrated microphone, speaker/headphone, or line-in connectors on the back panel.
14. If you installed an add-in network adapter and want to disable the integrated network adapter:
a. Enter system setup, select Integrated NIC Controller, and then change the setting to Off.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (20 of 68) [12/9/2007 11:22:24 PM]
2 not fully seated card 3
5 alignment bar 6
bracket within slot
alignment guide