Speed Setup - Mercury VesselView Link Operation Manual

Speed Setup

In the Speed Setup menus, there are three options for determining how VesselView will acquire speed information. If the vessel
is equipped with a GPS, the drop‑down menu will allow selection of available devices. If the vessel is equipped with a pitot
sensor, this option will be selected. If the vessel is equipped with a paddle wheel, then an option to select will drop‑down. After
the speed source has been selected, select Next to continue.
The pitot and paddle wheel source selection is shown in the following illustration. Select the engine or drive unit that transmits
the speed data to the VesselView.
a
a - PCM0 = starboard outer
b - PCM1 = port outer
c - PCM2 = starboard inner or center
d - PCM3 = port inner
90-8M0109374 JUNE 2016
eng
a
b
b
Section 2 - Initial Screens and Setup Wizard
c a
b
61529
c a
d
60056
Page 43