Mercury VesselView Link Operation Manual page 83

Section 4 - Setup and Calibrations
The pitot sensor data is sent by one of the outboards or drives on the vessel. Use the following images to determine the proper
selection.
a
Drive assignment options
a - PCM0 = starboard or starboard outer
b - PCM1 = port or port outer
c - PCM2 = starboard inner or center
d - PCM3 = port inner
Pitot type options include 100 psi and 200 psi. The 200 psi option only applies to select Mercury Racing outboard models.
The pitot multiplier will use 1.00 as a default setting and can be increased or decreased to correct speed display readings that
read too high or too low. For a low speed reading, increase the pitot multiplier by selecting the multiplier window and use the
on‑screen keypad to enter an amount. For a high speed reading, decrease the pitot multiplier by selecting the multiplier window
and use the on‑screen keypad to enter an amount.
Page 78
a
b
b
c a
b
61686
c a
d
60056
90-8M0109374 JUNE 2016
eng