1.1 NVR Installation
During installation of the NVR:
Ensure the device is installed in a well-ventilated, dust-free environment.
The device is designed for indoor use only.
Keep all liquids away from the device.
Ensure environmental conditions meet factory specifications.
Power down the device before connecting and disconnecting accessories and peripherals.
1.2 Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive(HDD). A factory recommended HDD
should be used for this installation.
Tools Required: Screwdriver.
NVR with 4 or 8 HDD
Steps
:
Remove the cover from the NVR by unfastening the screws on the rear panel.
(1)
(2) Insert the hard disk along the slot and fasten it.
(3) Connect the power & data cable to the NVR and HDD.
(4) Close the cover and fasten it with the screws.
NVR with 1 or 2 HDD
Steps
:
Remove the cover from the NVR by unfastening the screws on the side and rear panel.
(1)
Network Video Recorder User Manual
Chapter 1
Installation
1