Table of Contents
Advertisement
Network Video Recorder User Manual
Chapter 5 PTZ Controls
5.1 Configuring PTZ Settings
Follow the procedure to set the parameters for PTZ. The configuring of the PTZ parameters should be done before
you control the PTZ camera.
Steps:
(1) Enter the PTZ Setting interface.
System Setting->PTZ Setting
Figure 5.1 PTZ General Setting Interface
(2) Channel: Choose the channel.
(3) Protocol: Choose the protocol for your PTZ.
(4) Decoder Address: Choose the decoder address.
(5) Baud Rate: Select the baud rate.
(6) Data Bit: Select the data bit.
(7) Stop Bit: Select the stop bit.
(8) Verify: Select the verify, Non Parity by default.
(9) Stream Control: Select the stream control, None by default.
(10) Click Save button to save the settings.
5.2 Setting PTZ Preset, Cruise & Pattern
Before you start:
Please make sure that the preset, cruise and pattern should be supported by PTZ protocols.
Figure 5.2 PTZ Setting Interface
12
Advertisement
Table of Contents
