Table of Contents
Advertisement
6.1 Configuring Parameters
Before you start:
Make sure that the HDD has already been installed. If not, please install a HDD.
Steps:
(1) Enter the Record settings interface to configure the recording parameters.
Channel Setting->Recording Setting.
(2) Parameters Setting for Recording
Select the Channel you want to configure.
Select the Record Mode.
Click Setting button to set the record time, shown as the following figure.
Pre-Record: The time you set to record before the scheduled time or event.
Recording Delay: The time you set to record after the scheduled time or event.
Note:
Use the Copy to to do the same setting to the channel needed.
Network Video Recorder User Manual
Chapter 6 Recording
Figure 6.1 Record Setting Interface
Figure 6.2 Record Schedule Plan Setting Interface
14
Advertisement
Table of Contents
