Interfaces To Other Devices; Operating Modes / Operating Phases; Normal Mode; Special Mode - Interroll MultiControl Instruction Manual

2.6 Interfaces to other devices

When integrating the MultiControl into a conveyor system, danger spots may arise. These danger
spots are not part of these operating instructions and must be analysed during the development,
installation and commissioning of the conveyor system.
After integrating the MultiControl into a conveyor system, check the entire system for
➢
potentially new danger spots before switching on the conveyor.

2.7 Operating modes / Operating phases

Normal mode

Operation in the installed state at the end customer as a component in a conveyor in a complete
system.

Special mode

Special mode are all operating modes / operating phases that are necessary to ensure and
maintain safe normal operation.
Special mode
Transport/Storage
Assembly/Initial start-up
Cleaning
Maintenance/Repairs
Troubleshooting
Fault elimination
Decommissioning
Disposal
Version 3.0 (08/2018)
Translation of original instruction manual
Safety related information
Comment
-
In de-energized state
In de-energized state
In de-energized state
-
In de-energized state
In de-energized state
-
7