Mounting Procedure - High End Systems trackspot Bolt User Manual

CHAPTER 2
Installation and Setup

Mounting Procedure

Because of the variety of conceivable lighting designs, you should consider the procedure below
as a suggested guideline only. High End Systems cannot make specific recommendations for
your particular lighting design or venue.
CAUTION:
Always stand on a firm, stable surface to mount a trackspot Bolt
fixture.
To mount the fixture:
1. Attach a clamps using any of the three holes on the yoke. Use locking washers when
attaching the clamp to the yoke
2. Tighten the clamps firmly to the trackspot Bolt yoke and to the support.
3. Loop one or more suitable safety cables around the support and around the trackspot Bolt
yoke.
CAUTION:
Do not use the fixture handles as a safety cable attachment
point. The trackspot Bolt handles are intended only for
hand-lifting the fixture.
10 trackspot Bolt User Manual
®