AEMC 6255 User Manual page 22

1.800.561.8187
4.2.9. Selecting the Metal Type (nEtA)
1. Turn the rotary switch to the SET-UP position.
Press the ▲ button until "nEtA" appears on the top line of the display.
2.
Press the ► button to toggle through the choices of Copper (Cu),
3.
Aluminum (Al) or Other Metal. With each press of the right arrow button,
the metal type icon appears at the top of the display. "nEtA" appears on
the small display and the five digit alpha value appears on the large
display and then automatically returns to the top level of the metal set-
up menu.
To proceed to the next programming variable, press the ▲ button.
4.
4.2.10. Programming the Alpha Value (ALPH)
1. Turn the rotary switch to the SET-UP position.
Press the ▲ button until "ALPH" appears on the top line of the display.
2.
Press the ► button to begin programming the alpha value. See Table 2
3.
in §4.6 for common alpha values.
4. The current alpha value will be displayed with the leading digit flashing.
Use the ▲ button to change the leading digit. When the desired value is
5.
reached, press the ► button to move the next digit to the right.
Use the ▲ button to change this digit, then press the ► button to again
6.
move to the next digit to the right.
7. Repeat this process for each of the 5 digit locations.
After the 5th digit is programmed, press the ► button again to return to
8.
the top level of the alpha set up menu.
To proceed to the next programming variable, press the ▲ button.
9.
4.2.11. Selecting Temperature Units (dEg)
1. Turn the rotary switch to the SET-UP position.
Press the ▲ button until "dEg" appears on the top line of the display.
2.
Press the ► button to enter the degree units sub-menu.
3.
Use the ▲ button to toggle through the choices of Fahrenheit (dEgF) or
4.
Centigrade (dEgC).
Press the ► button to validate the selection and return to the top level
5.
of the Temperature units set-up menu.
To proceed to the next programming variable, press the ▲ button.
6.
22
www.
Micro-Ohmmeter Model 6255
information@itm.com
.com