Arctic Cat ZR 6000 R SNOCROSS 2015 Operator's Manual page 94

5. Replace the IFP seal; then amply lubricate the IFP and
place it into the reservoir.
6. Thread the EVOL reservoir onto the rebound eyelet; then
tighten to 12 ft-lb.
Assembling Shaft Assembly
1. With the shaft assembly clamped in the vise, install the
bottom-out bumper.
2. Place the Bearing Cap Seal Protector (p/n 0644-
268) onto the shaft, amply lubricate the protector,
and install the bearing assembly onto the shaft.
90
FFF
GGG
3. Install the lower and upper shim stack/piston assembly.

NOTE: Care must be taken that the preserved shim
stack/piston assembly be installed correctly.
4. Thread the lock nut onto the shaft; then tighten to 18 ft-lb.
Set the shaft assembly aside.
HHH
III
JJJ