Arctic Cat ZR 6000 R SNOCROSS 2015 Operator's Manual page 46

3. Using Flywheel Puller (p/n 0744-040) or suitable
substitute, remove the flywheel from the crank-
shaft by tightening the puller bolt, striking the
head of the puller bolt with a hammer, and tighten-
ing again. Repeat this procedure until the flywheel
is free. Account for the key.
CAUTION
To prevent damage to the crankshaft, the puller must
bottom on the insert and not on the crankshaft. Also,
do not thread puller bolts more than 12.7 mm (1/2 in.)
into the flywheel. Damage to the coils may result.
NOTE: To ensure the cleanliness of the flywheel
magnets, place the flywheel (with the magnets fac-
ing upward) on a clean bench.
4. Remove the ignition timing sensor.
5. Remove the cap screw securing the stator wiring
harness plate; then remove the plate.
42
RS014
6. Remove the Allen-head cap screws securing the
stator to the stator plate; then remove the stator
and account for the rubber grommet.
7. Remove the Allen-head cap screws securing the
magneto case to the crankcase. Account for four
alignment pins.
NOTE: Note the different-sized cap screws for
assembling purposes.
RS017
RS018A
RS019B
RS019A
FC019