Arctic Cat ZR 6000 R SNOCROSS 2015 Operator's Manual page 56

NOTE: The seal must be installed with its spring
side towards the crankshaft.
3. Install the snap ring securing the inner seal in the
crankcase.
4. Using the seal driver, carefully install the outer
water pump seal. Gently tap the seal down into
position until it seats itself against its flange.
5. Apply a thin coat of grease to the sealing surface of
the water pump driveshaft; then place the Oil Seal
Protector Tool (p/n 0644-219) at the end of the shaft.
Twist the driveshaft clockwise as it is pushed through
the oil and water pump seals; then remove the tool.
CAUTION
Be very careful not to damage the seals when installing
the oil pump driveshaft. Be certain to use the seal protec-
tor tool. Twist the driveshaft clockwise as it enters the seal
area and while it is being pushed through the seals.
52
6. Position the shim on the oil-injection pump end of
the driveshaft.
7. Position the upper crankcase half upside-down on
two wooden blocks; then install the C-ring, the
four bearing retaining pins, and the two crankcase
MS415
dowel pins.
MS988
8. Place the PTO-side crankshaft bearing into posi-
tion making sure the bearing retaining pin hole is
positioned inward.
NOTE: The bearing retaining pin hole is the hole
that does not go entirely through the bearing case.
FS191
RS043
RS046A
RS047A