Table of Contents
Advertisement
S
W
ETUP FOR
INDOWS
STEP 1: T
URN ON THE
Press and hold the small power button until the LED turns blue and the scanner beeps twice (low-high). The
LED should blink blue once per second to show that the Bluetooth radio is on but not connected.
Time after turning on scanner Bluetooth mode
0-5 minutes
2 hours
STEP 2: ENABLE AND CONFIGURE B
Note: Your Bluetooth software may vary from the screen shown.
1. To turn on your Bluetooth radio, tap Start
2. Select the Bluetooth icon and select the Mode tab. Select the Turn on Bluetooth check box to enable the
radio. If the box is already checked, then the Bluetooth radio is already enabled.
3. Select the Device tab and select Add new device.. or tap on Add at the bottom of the screen.
M
OBILE
B
CHS
LUETOOTH
Discoverable and connectable
If trigger button is not pressed,
scanner automatically powers off
SETTINGS
LUETOOTH
Settings, select the Connections tab.
Advertisement
Table of Contents
