Table of Contents
Advertisement
3
Push the MENU CANCEL/PRST/ITEM switch repeatedly to ITEM
until the cursor reaches the desired output (or use the rotary
encoder).
Note that the test output signal reverts to ENC (encoded) every time
the camcorder is switched on.
4
Press the rotary encoder to display a question mark to the left of the
display.
5
Turn the rotary encoder to select the desired output.
The R-G and B-G signal outputs can be selected only when R-G/B-
G SEL on the OPERATION 1 page is set to ON.
Refer to"maintenance manual" for information about the OPERATION
MODE page.
6
Press the rotary encoder, so that the question mark disappears.
7
To end the menu operation, set the MENU ON/OFF/PAGE switch to
OFF.
The setup menu disappears from the viewfinder screen and the
displays indicating the current status of the camcorder appear along
the top and bottom of the viewfinder screen.
4-9-4 Selecting the Aspect Ratio (DVW-709WS/
709WSP/790WS/790WSP Only)
Use the WIDE SCREEN page of the setup menu to select the aspect ratio
of the video output signal and other related items.
Selecting required functions
Follow the procedure below to select the required function.
Chapter 4 Adjustments and Settings for Recording
4
(Continued)
4-85
Advertisement
Table of Contents
