Table of Contents
Advertisement
2
Open the SHUTTER selector cover, then push the SHUTTER
selector from ON to SEL.
4
The current shutter setting appears for about 3 seconds in the setting
change and adjustment progress message display area of the
viewfinder screen.
E.g.: SS : 1/250 or : CLS : 60.6 Hz
3
Before the message from step 2 disappears, push the SHUTTER
selector to SEL again and repeat until the desired mode or speed
appears.
Pushing the SHUTTER selector to SEL repeatedly allows you to
cycle through the settings of mode and speed preselected on the
SHUTTER page of the setup menu.
Note that all modes and all standard-mode speeds listed in the table
on page 4-12 are preselected using the SHUTTER page of the setup
menu.
For more information about the SHUTTER page, see "Changing the range of
choice of shutter mode and speed settings" (page 4-19).
4-16
Chapter 4 Adjustments and Settings for Recording
SHUTTER selector
Advertisement
Table of Contents
