Table of Contents
Advertisement
qs TURBO GAIN button
When shooting under extremely poor lighting conditions, press the
button once to boost the video gain to the value preset with the menu (up
2
to 48dB, factory setting: 42dB). To stop boosting the gain, press the
button once more or use the GAIN switch.
qd WHITE BAL (white balance memory) switch
This switch determines the source of white balance settings.
PRST (preset): Adjusts the color temperature corresponding to the
position of the filter ring.
A or B: When the AUTO W/B BAL switch is pushed to WHT, the white
balance is automatically adjusted according to the current position of
the filter ring, and the adjusted value is stored in either memory A or
memory B. (There are two memories for each filter, so a total of
eight adjustments can be stored.) When the two-part FILTER
selector is in the same position as at when the WHITE BAL switch
was adjusted, the stored value is called from memory, and the
camcorder automatically adjusts itself to that value.
B (ATW): When this switch is set to B whereas, in the setup menu
OPERATION 1 page, B is set to ATW
You can use the AUTO W/B BAL switch even when the ATW is in
use.
Note that if the display mode (see 4-8-3) is set to 3 when this switch is
adjusted, the new setting will be indicated on the setting change/
adjustment progress message display area of the viewfinder screen for
about 3 seconds (e.g. WHITE : A CH).
....................................................................................................................................
1) ATW (Auto Tracing White balance)
The white balance of the picture being shot is adjusted automatically for the
varying lighting conditions.
2-20
Chapter 2 Locations and Functions of Parts and Controls
1)
, the ATW is activated.
Advertisement
Table of Contents
