Display Modes And Setting Change Confirmation/Adjustment Progress Messages - Sony DSR-400K/400PK Operating Instructions Manual

VF DISP 2 page
Item
DISP COLOR
TEMP
DISP BATT
1)
REMAIN
DISP DC IN
DISP 16:9/4:3 ID
DISP VTR STATUS Displays the VTR operating
DISP VTR
2)
TRIGGER
DISP TIME CODE Displays the time code.
DISP REC
FORMAT
1) When an Anton Bauer Intelligent Battery System or a BP-GL65/
GL95/L60S battery pack is used, the setting of this item determines
the display as follows.
INT: The remaining battery capacity is shown as a percentage when
there is a change, and when the capacity is low.
AUTO: The remaining battery capacity is shown as a percentage,
except that when this is impossible the battery voltage appears.
VOLT: The battery voltage is shown.
2) Displays only when an external VTR is connected to the
DV OUT connector.
2
Select whether the item should appear in the
viewfinder screen (the ON setting), or not appear (the
OFF setting).
Display modes and setting change
confirmation/adjustment progress
messages
You can limit or suppress the messages that give details of
setting changes and adjustment progress and results by
setting a display mode.
The conditions under which messages are displayed and
their correspondence with the display mode are as follows.
100
Setting the Status Display on the Viewfinder Screen and the LCD Monitor
Description
Displays the color temperature.
Displays the battery voltage and
remaining capacity of an internal
battery pack or an external battery
connected to the DC IN
connector.
Displayed when the power is
supplied from an external battery
connected to the DC IN
connector.
Displays the 16:9/4:3 mode
indicator.
status.
Displays the REC TRIGGER
switch setting.
Displays the recording format.
(i.LINK)
Setting change confirmation/adjustment progress
messages and display modes
Y: Message is displayed.
N: Message is not displayed.
Message display Message
condition
When the filter ND: n
selection has been (where n = 1, 2, 3, 4)
changed
When the gain setting GAIN: n
has been changed (where n = -3dB, 0dB,
3dB, 6dB, 9dB,12dB,
18dB, 24dB, 30dB,
36dB)
When the setting of WHITE: n
the WHITE BAL switch (where n = A CH, B
has been changed CH, PRESET) or
ATW: RUN
When the OUTPUT/ DCC: ON (or OFF)
DCC switches has
been set to DCC ON
or OFF
When the shutter : SS: 1/100 (or 1/125,
speed and mode 1/250, 1/500, 1/1000,
setting has been 1/2000, ECS, SLS)
changed*
When the black or E.g. WHITE: OK
white balance has
been adjusted
* This is also displayed for about 3 seconds when the SHUTTER switch is
set to ON.
To change the display mode
1
Display the VF DISP 1 page of the OPERATION
menu.
For details on menu operations, see "Basic menu
operations" on page 94.
2
Set VF DISP MODE to either 1, 2, or 3.
The display mode setting changes.
For details about the settings of 1 to 3, see the chart
above.
Display
mode
setting
1 2 3
N N Y
N N Y
N N Y
N Y Y
N Y Y
N Y Y