Planning A Decompression Dive; Leaving The Dive Planner - Uwatec Aladin ONE Matrix User Manual

F
NOTE: The no-dive warning and its
duration are displayed if the Aladin
One detects an increased risk due to
the accumulation of microbubbles.
* For more
considerations
warning, see chapter: Diving with your
Aladin One, section: Desaturation time,
No-fly time and No-dive warning.
4.1.2 Planning a decompression
dive
1. Activate the dive planner.
2. Set the desired depth by pressing the
left or right button and then confirming
with a press-and-hold of the right
button. The Aladin One shows the
bottom time (no-stop time + 1 minute)
and the appropriate decompression
information or level stop data,
respectively.
3. "Add" asks that you set the bottom
time. This is done by pressing the left or
right button. The Aladin One calculates
the decompression information for this
set bottom time.
CNS O % values higher than 199% will be
2
displayed as 199%.
22
information and safety
regarding the no-dive
Ascent time greater than 99 minutes is
displayed as "– –".
Deco stop depth deeper than 27m/90ft is
displayed as "– –: – –".
CNS O equal or greater than 75%: CNS
2
O % symbol starts flashing.
2
CNS O equal or greater than 100%: CNS
2
O % symbol and CNS O
2
flashing.
4.1.3

Leaving the dive planner

By pressing-and-holding the right button at
the time field you can exit the dive planner.
This will also occur after 3 minutes without
operation.
% value are
2
ALADIN ONE USER MANUAL