Ethernet 10Base5 - Lucent Technologies PortMaster PM-2 Hardware Installation Manual

Connect an Ethernet Cable

Ethernet 10Base5

Follow these instructions to connect an Ethernet cable to the Ethernet 10Base5
(AUI) port.
Required Equipment
An RG-11 50-ohm coaxial cable with a DB-15 female connector
This cable is available from most computer equipment suppliers.
Procedure
1. Connect the cable to the Ethernet AUI port (PM-2i shown).
2. Set DIP switch 4 down and DIP switch 5 up (PM-2i shown).
2-12
ISDN/U ISDN/U ISDN/U
S0-S1 S2-S3 S4-S5
C0 - DIAG
1189-0007
1187_0007
ISDN/U ISDN/U ISDN/U
S0-S1 S2-S3 S4-S5
C0 - DIAG
1 2 3 4 5
ISDN/U ISDN/U ISDN/U
S6-S7 S8-S9 HD
ETHERNET
ISDN/U ISDN/U ISDN/U
S6-S7 S8-S9 HD
ETHERNET
1189-0010
Communications Server Hardware Installation Guide