Table of Contents
Advertisement
5.2
Pre-installation Operational Check
Although every oxygen generator is tested thoroughly after it is manufactured,
perform the following test to insure that no damage occurred during shipping and
handling:
1)
Make sure the panels fasten securely to the unit.
2)
Make sure the gross particulate filter completely covers the air intake.
3)
Make sure the power cord is securely attached to the unit.
4)
Connect the power cord to a properly grounded electrical outlet.
5)
Set the ON/OFF power switch to the ON position.
6)
Listen for the sound of the air compressor in operation.
7)
Verify that exhaust air emits from the air exhaust panel on the left side of the
enclosure.
8)
Rotate clockwise the knob on the flowmeter until it stops at the fully-closed
position. Verify that the flowmeter indicates zero flow.
9)
Rotate counterclockwise the knob on the flowmeter until the flowmeter
indicates 100% flow.
When nothing connects to the oxygen outlet, the ball in the flowmeter should rise
to the top of the flowmeter. If this does not occur, contact the AirSep Commercial
Products Service Department.
10) Set the ON/OFF power switch to OFF.
5-2
Locate the oxygen generator in an area where the ambient air
temperature remains between 4 C (40 F) and 44 C (112 F) to
prevent damage not covered under the AirSep Corporation
Product Warranty.
AirSep oxygen generators are sold for indoor use only. Make
sure the area that surrounds the oxygen generator is well
ventilated, and provide sufficient space around the unit [at least
one meter (three feet)] to allow for cool air flow as well as to
allow safe operation and maintenance.
AirSep
Onyx/Onyx+/Onyx Ultra Instruction Manual
®
Corporation
Hide quick links:
Advertisement
Table of Contents
