Table of Contents
Advertisement
2.0 Installation
A wall bracket has been supplied with the system. Install the bracket on a sturdy
vertical surface using a level. Attach the bracket with bolts or screws capable of
supporting the unit. The backplate of the unit has large through holes for sighting in
the wall bracket's hanger screws. If necessary, remove the top cover and use the
through holes to assist the installer hanging the unit. Re-attach the cover. Do not lay
items on the cover; it is not designed to carry heavy loads.
Be certain there is sufficient access space around the Workhorse Oxygen
Concentrator to perform normal maintenance and service. Also ensure there will
be a free flow of cooling air around the unit. Connect the unit to a grounded power
source rated for the voltage and current requirements stated on the label on the
unit.
2.1
OXYGEN HOOK-UP
The oxygen outlet connection is ⅛" female National Standard Pipe Thread (NPT)
and is located on the front of the Workhorse Oxygen Concentrator. Prevent the
rotation of the bulkhead fitting in the unit when making your connection to the unit.
Workhorse-8 Instruction Manual
There are packaging materials that must be removed from inside
the Workhorse enclosure before operation. Do not attempt to
operate the Workhorse Oxygen Concentrator without removing
these packaging materials, as severe damage will result.
The location of the Workhorse Oxygen Concentrator must be
well ventilated to prevent suffocation of personnel. Refer to
the recommendations in the Compressed Gas Association
Guide P-8.1–2016 "Safe Installation and Operation of PSA and
Membrane Oxygen and Nitrogen Generators."
Choose a location for the Workhorse Oxygen Concentrator that
does not allow rain or condensation to contact the unit. The
Workhorse Oxygen Concentrator is not weather proof. It must
be operated indoors or in an enclosure in a non-condensing
environment.
AirSep Corporation
7
Advertisement
Table of Contents
