Quadstick User Manual page 133

Currently available voice commands. The contents of this pane will change when different vocola files
are active.
Program message transcript
A serial connection (Bluetooth SSP or cable), is normally required for voice commands and, if one is
found, the message "Found a serial connection to QuadStick" will display here. If the Quadstick is
connected to the PC via USB and "Enable Voice Commands over USB" is on in the Misc tab, voice
commands may be used without a serial connection. If the voice commands are to be used with a game
console, then a serial connection is required.
Controller output status
When the Quadstick is connected to the PC, this table will display the current values of the outputs. This
can be used for troubleshooting configuration files.
Natlink Window:
The "Messages from Natlink" window will display when Dragon Naturally Speaking starts. It should be inspected
for any error messages:
133