Samsung CLX-8380ND User Manual page 39

Media type
Transparencies • To avoid damaging the machine, use only
transparencies designed for use in laser printers.
• Transparencies used in the printer must be able
to withstand the machine's fusing temperature.
Check your machine's specification to view the
fusing temperature, see page 15.1.
• Place them on a flat surface after removing them
from the machine.
• Do not leave them in the paper tray for long
periods of time. Dust and dirt may accumulate
on them, resulting in spotty printing.
• To avoid smudging caused by fingerprints,
handle them carefully.
• To avoid fading, do not expose printed
transparencies to prolonged sunlight.
• Ensure that transparencies are not wrinkled,
curled, or have any torn edges.
Caution
• Recommended media: Transparency for
a Color Laser Printers produced by HP,
Xerox and 3M.
• It is not recommended to use
paperbacked transparencies such as
Xerox 3R91334, which can cause a jam
or be scratched.
Guidelines Media type
Labels • To avoid damaging the machine, use only labels
designed for use in laser printers.
• When selecting labels, consider the following
factors:
- Adhesives: The adhesive material should be
stable at your machine's fusing temperature.
Check your machine's specification to view the
fusing temperature, see page 15.1.
- Arrangement: Only use labels with no
exposed backing between them. Labels can
peel off sheets that have spaces between the
labels, causing serious jams.
- Curl: Prior to printing, labels must lie flat with
no more than 13 mm ( 5 inches) of curl in any
direction.
- Condition: Do not use labels with wrinkles,
bubbles, or other indications of separation.
• Make sure that there is no exposed adhesive
material between labels. Exposed areas can
cause labels to peel off during printing, which
can cause paper jams. Exposed adhesive can
also cause damage to machine components.
• Do not run a sheet of labels through the machine
more than once. The adhesive backing is
designed for only a single pass through the
machine.
• Do not use labels that are separating from the
backing sheet or are wrinkled, bubbled, or
otherwise damaged.
Card stock or Do not print on media smaller than 98 mm (3.86
custom-sized inches) wide or 148 mm (5.83 inches) long.
materials
• In the software application, set margins at least
6.4 mm (0.25 inches) away from the edges of
the material.
Preprinted • Letterhead must be printed with heat-resistant
paper
ink that will not melt, vaporize, or release
hazardous emissions when subjected to the
printer's fusing temperature for 0.1 second.
Check your machine's specification to view the
fusing temperature, see page 15.1.
• Letterhead ink must be non-flammable and
should not adversely affect printer rollers.
• Forms and letterhead should be sealed in a
moisture-proof wrapping to prevent changes
during storage.
• Before you load preprinted paper, such as forms
and letterhead, verify that the ink on the paper is
dry. During the fusing process, wet ink can come
off preprinted paper, reducing print quality.
Note
Using photographic paper or coated paper may cause
problems, requiring repairs. Such repairs are not covered by
Samsung's warranty or service agreements.
4.5
<Loading originals and print media>
Guidelines