Altitude Adjustment; Machine's Basic Settings; Setting The Authentication Password; Setting The Date And Time - Samsung CLX-8380ND User Manual

Altitude adjustment

The print quality is affected by atmospheric pressure, which is determined
by the height of the machine above sea level. The following information
will guide you on how to set your machine to the best print quality or best
quality of print.
Before you set the altitude value, find the altitude where you are using the
machine.
0
1 Press Machine Setup on the control panel.
2 Press Admin Setting.
3 When the login message appears, enter password with number
keypad and press OK. (Page 3.5)
4 Press the General tab.
5 Press Altitude Adjustment.
6 Select appropriate option, and then click OK.
Note
Enter your machine's IP address as the URL in a browser and
click Go to access the web site of your machine. Click Machine
Settings > Setup (or Machine Setup) > Altitude Adj. Select
the appropriate altitude value, and then click Apply.
Value
High 3
High 2
High 1
Normal
3.5
<Getting Started>

Machine's basic settings

After installation is complete, you may want to set the machine's default
settings. Check the next explanation if you would like to set or change
values.

Setting the authentication password

To set your machine up or change the settings, you have to login. To
change password, follow the next steps.
1 Press Machine Setup on the control panel.
2 Press Admin Setting.
3 When the login message appears, enter password. Touch the
password input area, then the question marks appears, use the
number keypad on the control panel to enter the password. Then,
press OK. (Factory setting:1111)
4 Press the Setup tab > Authentication.
5 Press Change Admin. Password.
6 Enter old and new password, and then confirm the new password.
7 Press OK.

Setting the date and time

When you set the time and date, they are used in Delay fax and Delay
Print, also they are printed on reports. If, however, they are not correct,
you need to change it for correct time being.
1 Press Machine Setup on the control panel.
2 Press Admin Setting.
3 When the login message appears, enter password with number
keypad and press OK. (Page 3.5)
4 Press the General tab > Date & Time > Date&Time.
5 Select date and time using left/right arrows. Or touch the insert area
and use the numeric keypad on the control panel.
6 Press OK.
Note
To change the format of date and time, press Date Format and
Time Format.