Features; System; Parts Identification; System Components - DIG LEIT-2 Operating Instructions Manual

E.

Features

• All power is provided by an internal photovoltaic module and
microelectronic energy management system fueled by ambient light
• Multilingual software in English, Spanish, Italian, French, German and
Portuguese
• Controller has a 2-way radio with operating range of up to 350 ft (100
meters) line of sight
• Radio frequency is in the ISM band 902-928 MHz (868 MHz international)
CE and FCC certified
• Default program; if not programmed the controller defaults to 5 minutes per
day (if ID has been entered)
• Manual run via the RC2 handset
• Client ID enables the user to have a unique identity code for the controllers
and handset; this is a security feature, which locks out unauthorized users
• The LEIT-2 operates up to 2 Unimax S-305DC solenoids installed on most
valves using one of DIG's solenoid valve adapters
• Dedicated Rain Sensor input allows for a sensor connection promoting
better water efficiency
• Electrical protection for up to 50 volts; resistant to damage from lightning
and currents from power lines
• Non-volatile memory retains program integrity indefinitely (excludes time)
• Built from tough, rugged material - resistant to harsh environmental
conditions
• Environmentally friendly: Certified lead free, uses light as a source of
energy
• Waterproof, complies with IP68 requirements
• Mounting configurations include valve mounting, valve box mounting and
column mounting
6
1.

System

1.1 Parts Identification

1. PVM Photovoltaic module harnesses the
energy of light and generates the electricity
to power the unit day and night in any of
weather condition
2. Antenna
3. Stations and sensor wires

1.2 System Components

To properly install the LEIT-2 controller, the following components will be
needed:
1. Control unit: LEIT-2, 2 station controller
2. The controller is installed using 1 of 3 mounting
configurations available:
a. Valve box mounting dome, color: green
(Model 30-30)
b. Mounting column bracket
(Model 30-831)*
c. Valve clip attachment
(Model 30-832)
c
b
If the mounting column plastic attachment is used, a mounting column is also
needed. Use one of the two following mounting columns: model MCOL2S
(small) 25" (63 cm) or MCOL2L (large) 50" (128 cm) mounting column including
mounting tool kit with cement glue (to firmly attach mounting bracket to
column).
c b
d
a
7