Safety Warnings And Guidelines - Monoprice Delta Pro User Manual

SAFETY WARNINGS AND GUIDELINES

Safety Warnings and Guidelines
1. Be careful not to damage the glass build plate.
2. Take care to avoid touching hot parts, including heat blocks,
nozzle, extruded filament, and the heated build plate.
3. Keep the printer and all accessories out of reach of small
children.
4. Do not remove or disconnect the USB cable when printing
from a computer.
5. Do not pull or twist the black cable harness at any time.
6. Do not force or tear anything during unpacking and setup.
This may cause damage to the printer and/or its accessories.
7. Do not reach inside the printer during operation. Always allow
the printer and extruded filament to cool before reaching
inside.
8. Ensure that the printer is turned off and unplugged from its
power source before making repairs or performing service.
9. Do not install this device on an unstable surface where it
could fall and cause either personal injury or damage to the
device and/or other equipment.
10. Do not subject the product to extreme force, shock, or
fluctuations in temperature or humidity.
11. This device is intended for indoor use only.
12. Do not expose this device to water or moisture of any kind.
Do not place drinks or other containers with moisture on or
4
near the device. If moisture does get in or on the device,
immediately unplug it from the power outlet and allow it to
fully dry before reapplying power.
13. Do not touch the device, the power cord, or any other
connected cables with wet hands.
14. Use only in a well-ventilated area. Do not use in confined
spaces.
15. Prior to operation, check the unit and power cord for physical
damage. Do not use if physical damage has occurred.
16. Before plugging the unit into a power outlet, ensure that the
outlet provides the same type and level of power required by
the device.
17. Unplug this device from the power source when not in use.
18. Take care to prevent damage to the power cord. Do not allow
it to become crimped, pinched, walked on, or become tangled
with other cords. Ensure that the power cord does not present
a tripping hazard.
19. Never unplug the unit by pulling on the power cord. Always
grasp the connector head to unlock it from the port.