Table of Contents
Advertisement
4.3
Drivers Installation 3
Installation :
Applicable for Windows NT 4.0
1. Insert the SBC-657 CD into the CD ROM Drive.
2. Start system with Windows NT 4.0 installed.
IMPORTANT: When the "Please select the operating system to
start..." message is displayed, select "Windows NT Workstation
Version 4.00 [VGA mode]".
3. From Start, select the Settings group, then click on the
Control Panel icon.
4. In the Control Panel, select the desired device and click on the
icon.
5. Follow the step-by-step instruction and click on OK button.
6. Click on the Have Disk... button.
7. Key in CD-ROM path and specify component drivers, then click
on the OK button.
8. From the list of displayed devices, select your desired device.
9. If a message appears stating the driver is already installed on the
system, and asks if you want to use the current or new drivers, be
sure to select the New button.
12. If prompted for the driver disk a second time, click on the
Continue button.
(Notice: In some cases the system will ask you to insert Windows
NT CD. Follow its instructions to complete the setup procedures.)
13. When the message The drivers were successfully installed is
displayed, remove the display driver disk, then click on the OK
button.
14. Reboot the system.
Chapter 4 Driver Installation 71
Advertisement
Table of Contents
