Strymon Riverside User Manual page 29

Riverside
- Multistage Drive
MIDI – Configuring Riverside to Use MIDI
This determines what kind of MIDI data is sent out by Riverside. Note
that if you are only sending MIDI data to Riverside – the most common
configuration – the MIDI Output mode must be set to OFF.
Step 3 – Set MIDI Output Mode
Press and hold the FAVORITE footswitch
1
while powering up the pedal. Once both
LEDs flash, release the footswitch.
AMBER - THROUGH: Incoming MIDI messages are sent out of
Riverside without any additional MIDI messages generated by
Riverside.
RED
- OFF (default): No MIDI messages are sent out of Riverside.
TIP: A simple way to check that communication is working is to
send CC #10 with a value of 127 when the FAVORITE footswitch is
off. This will turn the FAVORITE footswitch on if MIDI is properly
connected and configured.
(cont.)
Turn the MIDDLE
2
knob to select what
kind of MIDI data is
sent from Riverside
to other MIDI devices.
Both LEDs will flash
momentarily as the
mode is changed.
GREEN - ON: Using
Riverside's knobs and
switches generates
MIDI messages that are
sent out of Riverside.
®
pg 29