Entering The Parameter Block Address - Siemens SIMATIC TD 200 User Manual

Operating the TD 200

Entering the Parameter Block Address

The Setup Menu allows you to designate a V memory location where the
parameter block (or an offset to the location of the parameter block) is stored in the
CPU. The default parameter block address is V0. You can enter any V memory
address up to V999.
Use the following procedure to enter the V memory address of the parameter block
(or the location of the offset to the parameter block):
Key
1.
ESC
2.
3.
4.
ENTER
5.
ENTER
Note
Pressing ESC at any time while you are entering the address of the parameter
block aborts the edit and restores the previous address for the parameter block.
3-18
Action
The TD 200 enters the Menu mode.
The TD 200 scrolls down the menu
options five times.
The TD 200 scrolls down the Setup
Menu to the parameter block address
option.
Press to move the cursor to the
ENTER
address field. Use the up or down
arrow keys to display the correct
address.
Press to store the V memory
ENTER
address of the parameter block.
Display
MENU MODE:
VIEW MESSAGES
SETUP MENU:
TD 200 ADDRESS
SETUP MENU:
PARM ADDRESS
SETUP MENU:
PARM ADDRESS
SETUP MENU:
PARM ADDRESS 30
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01
1
0
0